Tekelec IP7 Secure Gateway Administration Manual page 707

Database Administration Manual - IP7 Secure
Gateway
chg-ip-lnk command with these mandatory
:loc=<card location of the link>
:port=<the ethernet interface on the card, A or B>
and with at least one of these optional
:ipaddr = <IP address>
:submask = <subnet mask of the IP interface>
:mactype = <dix, 802.3>
(See Notes 1, 2, and 3)
rept-stat-card:loc=<card
Notes:
1. If either the ipaddr or submask parameters are specified, then both
parameters must be specified, unless the ipaddr=0.0.0.0 parameter is
specified, then the submask parameter is not required.
2. The ipaddr=0.0.0.0 parameter disables the IP link.
3. If the auto=yes parameter is specified, then the duplex and speed
parameters cannot be specified.
Sheet 7 of 9
910-6278-001 Revision A, January 2012
From
Sheet 6
Enter the
parameters:
parameters:
:auto = <yes, no>
:duplex = <half, full>
:speed = <10, 100>
To
Sheet 8
Enter the
alw-card:loc=<card
location> command
Enter the
Sheet 8
location> command
IPSG M2PA and M3UA Configuration Procedures
Enter the
rtrv-ip-lnk command with this
parameter:
:loc=<loc parameter value
specified in the previous step>
Was the state
No
of the card changed on
Sheet 2?
Yes
To
707