Tekelec IP7 Secure Gateway Administration Manual page 749

Database Administration Manual - IP7 Secure
Gateway
rtrv-assoc command
Is the required
IP link shown in the
rtrv-assoc output? See
rtrv-card command with this
:loc= <card location from the
rtrv-assoc output>
Enter the
rtrv-assoc command with this
parameter.
:loc = <the card location that
will host the new
association>
How many
associations are
displayed?
This is the maximum number
of IPSG associations the IPSG
card may contain. Choose
another IPSG card.
Choose another card
from the rtrv-assoc
output whose
adapter value is
M3UA.
Notes:
1. The IP link is shown by the entries in the CARD LOC and IPLINK PORT columns. The ADAPTER
value of the association must be M3UA.
2. The IP address of the IP link should be assigned to the host name, shown in the rtrv-ip-host
output, that will be assigned to the association.
3. The values of the lhost and alhost parameters must be in the LOCAL HOST column in the
rtrv-ip-host output.
Sheet 1 of 2
910-6278-001 Revision A, January 2012
Enter the
No
Note 1.
Yes
Enter the
parameter.
What is the
IPSG
value in the TYPE
column of the rtrv-card
output?
Less than
32
To
Sheet 2
32
The links and host assigned to
this card cannot be used in this
procedure.
Do you wish to
No
use the card shown in the
rtrv-card output to configure an
M3UA association?
IPSG M2PA and M3UA Configuration Procedures
Enter the
rtrv-ip-lnk command
Is the required
IP link in the IP Link
Enter the
rtrv-ip-host command with
this parameter.
:display=all
SS7IPGW,
IPGWI
Is the required
host name shown in the
rtrv-ip-host output? See
Notes 2 and 3.
Perform the "Adding an IP
Host" procedure in this
chapter and add the
required host name.
Yes
M3UA or SUA Association"
No
table?
Perform the
Yes
"Configuring an IP
Link" procedure in
this chapter and
add the required IP
link
Yes
No
To
Sheet 2
Perform the Adding an
procedure.
749