Tekelec IP7 Secure Gateway Administration Manual page 992

Database Administration Manual - IP7 Secure
Gateway
Enter the chg-assoc command with these
parameters:
:aname = <aname value from the rtrv-assoc output>
:open = no.
Repeat this step for each association shown in the
rtrv-assoc output.
Enter the chg-assoc command with these
parameters:
:aname = <aname value from the rtrv-assoc output>
:open = yes.
Repeat this step for each association shown in the
rtrv-assoc output.
Enter the pass command with these
parameters:
:loc=<card location specified in the
dact-slk command>
:cmd="sctp -a <name of the assocation
specified in the chg-assoc command>"
Repeat this step for each association
shown in the rtrv-assoc output.
Sheet 2 of 3
910-6278-001 Revision A, January 2012
From
Sheet 1
:link = <signaling link on the card specified
IPSG M2PA and M3UA Configuration Procedures
Does the checksum
algorithm value in all the
associations displayed in the previous
step match the checksum algorithm value
specified in the chg-sg-opts
command on Sheet 1?
Yes
Enter the act-slk command with these
parameters:
:loc = <location of the card specified in the
dact-slk command on Sheet 1>
in the dact-slk command on Sheet 1>.
Repeat this step for each signaling link
assigned to the card.
To
Sheet 3
No
Contact the Customer
Care Center. Refer to
the "Customer Care
Center" section in
Chapter 1 for the
contact information.
992