Tekelec IP7 Secure Gateway Administration Manual page 776

Database Administration Manual - IP7 Secure
Gateway
Command Completed.
If the desired linkset is shown in the rept-stat-iptps output, continue the procedure with
6.
If the desired linkset is not shown in the rept-stat-iptps output, add the linkset by performing
Adding an IPSG M2PA Linkset
the
If a new IPSG card was added in
If the signaling link will be assigned to an existing IPSG card, the RSVDSLKTPS value that is
assigned to the linkset will be assigned to the signaling link. The sum of the TPS used by all the
signaling links that are assigned to the IPSG card cannot exceed 5000 TPS. The TPS used by the
IPSG card and the TPS used by each signaling link that is assigned to the IPSG card is shown
by entering the rtrv-slk command with the location of the IPSG card. If the 5000 TPS limit
for the IPSG card will be exceeded by adding the IPSG M2PA signaling link, one of these actions
must be performed.
Another IPSG card must be used for the IPSG M2PA signaling link. Repeat this procedure
from Step
The RSVDSLKTPS values for the linksets shown in the rtrv-slk output for the IPSG card,
shown in
Perform these procedures as necessary to change the RSVDSLKTPS values for the linksets.
After the linksets have been changed, continue the procedure with
Changing an IPSG M2PA Linkset
Changing an IPSG M3UA Linkset
6. Display the linkset that the signaling link will be assigned to using the rtrv-ls command,
specifying the name of the linkset that the signaling link is being assigned to.
For this example, enter this command.
rtrv-ls:lsn=lsipgw
This is an example of the possible output.
rlghncxa03w 10-07-17 11:43:04 GMT EAGLE5 42.0.0
LSN
lsipgw
---------------- -----------
RANDSLS
off
IPSG
yes
ADAPTER
m3ua
TPSALM
rsvdslktps 80%
910-6278-001 Revision A, January 2012
procedure. Continue the procedure with one of these actions.
Step
3.
Step 4, must be reduced enough to allow the IPSG M2PA linkset to be added.
APCA (SS7) SCRN
010-010-101 none
SPCN CLLI
IPGWAPC GTTMODE
no CdPA
RSVDSLKTPS
500
LSUSEALM
IPSG M2PA and M3UA Configuration Procedures
3, continue the procedure with
L3T SLT
SET SET BEI LST LNKS ACT MES DIS SLSCI NIS
1 1 no A 1
TFATCABMLQ MTPRSE ASL8
---
CGGTMOD
no
MAXSLKTPS
4000
SLKUSEALM
80%
Step 7.
Step 7.
GWS GWS GWS
off off off ---
--- ---
Step
off
776