Figure 117: Changing The Attributes Of An Ipsg Association - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 4
Enter the chg-assoc command with this
mandatory parameter:
:aname=<name of the association being
changed>
and with any of these optional parameters.
:lport = <TCP port for the local host>
:rhost = <remote host name>
:rhosttype=<primary or alternate>
rhostval=<relaxed, match>
:rport = <TCP port for the remote host>
:alw = <yes, no>
:rmode = <rfc or lin>
:rmin = <10
:rmax = <10
:rtimes = <3
:cwmin = <1500
:istrms = <1 or 2>
:ostrms = <1 or 2>
:m2patset = <1
:ver = <d6 or rfc>
:uaps = <1
:rtxthr = < 0
(See the Notes)
Perform the Changing the Buffer
Size of an IPSG Association"
Notes:
1. If any optional parameters are not specified with the chg-assoc command, those values are not changed.
2. The value of the rhost parameter is a text string of up to 60 characters, with the first character being a letter. The command
input is limited to 150 characters, including the hostname.
3. If the value of the open parameter is yes, only the values of the alw and rtxthr parameters can be changed. To change the
values of the other parameters, the value of the open parameter value must be no.
4. The value of the rmin parameter must be less than or equal to the rmax parameter value.
5. The M2PA version of the association determines the version of the M 2PA timer set that is assigned to the association . For
example, if M2PA timer set 3 is assigned to the M2PA association , and the association is an RFC M2PA association , the RFC
version of M2PA timer set 3 is used with the association. If M2PA timer set 7 is assigned to the M2PA association , and the
association is a Draft 6 M2PA association , the Draft 6 version of M2PA timer set 7 is used with the association.
6. The m2patset and ver parameters can be specified only for IPSG M2PA associations .
7. If the adapter parameter value for the association is M3UA, the alw parameter cannot be specified.
Sheet 5 of 5

Figure 117: Changing the Attributes of an IPSG Association

910-6278-001 Revision A, January 2012
1000>
1000>
12>
409600>
20>
10>
65535>
procedure in this chapter.
IPSG M2PA and M3UA Configuration Procedures
Was the
Yes
value of the open
parameter changed
on Sheet 3?
No
Enter the
chg-db:action=backup
:dest=fixed command.
Do you wish
to change the LHOST or
ALHOST values of the
IPSG association?
Perform the Changing the
No
Do you wish to
Yes
change the buffer size
of the IPSG
association?
Enter the chg-assoc
command with these
parameters.
:aname=<association
name being changed>
:open=yes
Enter the rtrv-assoc
command with this
parameter.
:aname=<association
name specified with the
chg-assoc command>
Yes
Host Values of an IPSG
Association" procedure in
this chapter.
No
This procedure is
finished.
936