Tekelec IP7 Secure Gateway Administration Manual page 650

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-tps
command.
Will adding the
new IPSG card exceed
the maximum total provisioned
system TPS value? See
Note 1.
Enter the rtrv-card
command.
Are the required
unprovisioned card slots
shown in the rtrv-card output?
See Note 2.
Enter the rtrv-shlf
command.
Have all the
shelves been
provisioned?
Yes
This procedure cannot
be performed as no card
slots are available for the
new card.
Sheet 1 of 2
910-6278-001 Revision A, January 2012
Yes
Perform the Activating the HIPR2 High
Rate Mode Feature" procedure to enable
and turn on the HIPR2 High Rate Mode
feature. When the HIPR2 High Rate
Mode feature is enabled and turned on,
No
the maximum total provisioned system
TPS value is increased to 750,000.
Yes
Visually verify that the
No
IP card has been
installed into the
EAGLE 5 ISS.
Enter the ent-shlf command
with these parameters.
loc=<location of the shelf:
No
1200, 1300, 2100, 2200, 2300,
3100, 3200, 3300, 4100, 4200,
4300, 5100, 5200, 5300, or
6100>
:type=ext
Notes:
1. The IPSG card uses 5000 - 10,000 TPS.
2. See the Card Slot Selection section in
the Adding an IPSG Card" procedure in
the Database Administration Manual
Secure Gateway.
IPSG M2PA and M3UA Configuration Procedures
What is
750,000
the maximum total
provisioned system
TPS value?
500,000
Insert the IP card into the desired card
slot following the rules described in
the Card Slot Selection section. This
section is in the Adding an IPSG
Card" procedure in the Database
Administration Manual
Has UAM 0002
been generated?
Perform the alarm clearing
procedure for UAM 0002 in
the Unsolicited Alarm and
Information Messages manual
to clear the alarm.
.
IP7
This
procedure cannot
be performed.
Has the
Yes
IP card been
installed?
No
IP7 Secure
Gateway.
No
Yes
To
Sheet 2
650