Tekelec IP7 Secure Gateway Administration Manual page 699

Database Administration Manual - IP7 Secure
Gateway
This message should appear.
rlghncxa03w 06-10-28 21:20:37 GMT EAGLE5 36.0.0
Card has been allowed.
17. Verify the in-service normal (IS-NR) status of the IP card using the rept-stat-card command.
For example, enter this command.
rept-stat-card:loc=1201
This is an example of the possible output.
rlghncxa03w 10-12-01 09:12:36 GMT EAGLE5 43.0.0
CARD VERSION
1201 133-003-000
ALARM STATUS
BLIXP GPL version = 133-003-000
IMT BUS A
IMT BUS B
CURRENT TEMPERATURE
PEAK TEMPERATURE:
SIGNALING LINK STATUS
SLK
A
Command Completed.
18. Activate the signaling link from
Note: If Step 5
For example, enter this command.
act-slk:loc=1201:link=a
The link changes its state from OOS-MT-DSBLD (out-of-service maintenance-disabled) to IS-NR
(in-service normal).
The output confirms the activation.
rlghncxa03w 06-10-07 11:11:28 GMT EAGLE5 36.0.0
Activate Link message sent to card
19. Verify the in-service normal (IS-NR) status of the signaling link using the rept-stat-slk
command.
For example, enter this command.
rept-stat-slk:loc=1201:link=a
This message should appear.
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
SLK LSN
1201,A nc001
Command Completed.
20. Perform the Configuring an IP Card
non-zero value, where the network portion of the default router IP address matches the network
portion of the IP link's new IP address.
910-6278-001 Revision A, January 2012
TYPE GPL
E5ENET IPSG
= No Alarms.
= Conn
= Conn
= 32C ( 90F)
= 39C (103F)
PST
IS-NR
Step 5
was not performed, continue the procedure with
CLLI
----------- IS-NR
procedure and change the IP address of the default router to a
IPSG M2PA and M3UA Configuration Procedures
PST
IS-NR
[ALARM TEMP:
[06-05-02 13:40]
LS CLLI
nc001 -----------
using the act-slk command.
PST SST
SST AST
Active -----
60C (140F)]
Step 20.
AST
699