Database Administration Manual - IP7 Secure
Gateway
IP Appl Sock/Assoc table is (4 of 4000) 1% full
Assoc Buffer Space Used (16 KB of 3200 KB) on LOC = 1203
If no associations referencing the host name being removed in this procedure are shown in this
step, continue the procedure with
Any associations referencing the host name must either be removed or the host name assigned to
the association must be changed.
To remove the associations, perform the
Continue the procedure with
To change the host name assigned to the associations, perform the
M3UA or SUA Association
Continue the procedure with
changed.
5. Delete IP host information from the database by entering the dlt-ip-host command.
For example, enter this command.
dlt-ip-host:host= IPNODE1-1205
When this command has successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:19:37 GMT EAGLE5 36.0.0
DLT-IP-HOST: MASP A - COMPLTD
6. Verify the changes by entering the rtrv-ip-host command with the host name specified in
5.
For this example, enter this command.
rtrv-ip-host:host= IPNODE1-1205
The following is an example of the possible output.
rlghncxa03w 09-07-28 21:20:37 GMT EAGLE5 41.1.0
No matching entries found.
IP Host table is (10 of 2048) 1% full
7. Back up the new changes using the chg-db:action=backup:dest=fixed command.
These messages should appear, the active Maintenance and Administration Subsystem Processor
(MASP) appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
910-6278-001 Revision A, January 2012
IETF M3UA and SUA Configuration Procedures
Step
5.
Removing a M3UA or SUA Association
Step 5
after the associations have been removed.
procedure.
Step 5
after the host name assigned to the associations have been
procedure.
Changing the Host Values of a
Step
482
Need help?
Do you have a question about the IP7 Secure Gateway and is the answer not in the manual?
Questions and answers