Database Administration Manual - IP7 Secure
Gateway
Removing IPSG Components
This section describes how to remove the following components from the database.
An IPSG Card – Perform the
An IPSG Linkset – Perform the
An IP Host – Perform the
An IP Route – Perform the
An IPSG Association – Perform the
An IPSG M2PA Signaling Link – Perform the
An IPSG M2PA Signaling Link – Perform the
Removing an IPSG Card
Use this procedure to remove an IPSG card, a card running the ipsg application, from the database
using the dlt-card command.
The card cannot be removed if it does not exist in the database. Before removing the card from the
database, the signaling links assigned to the card must be removed.
CAUTION: If the IPGWx card is the last IP card in service, removing this card from the
database will cause traffic to be lost.
1. Display the cards in the database using the rtrv-card command.
This is an example of the possible output.
rlghncxa03w 09-04-13 17:00:02 GMT
CARD
TYPE
1101
DSM
1102
TSM
1104
DCM
1113
GSPM
1114
TDM-A
1115
GSPM
1116
TDM-B
1117
MDAL
1201
LIMDS0
1203
LIMDS0
1204
LIMATM
1205
ENET
1207
ENET
1303
DCM
1305
DCM
Select a card whose application is IPSG.
2. Display the linksets that are assigned to the IPSG card by entering the rtrv-ls command with
the names of the linksets that are assigned to the IPSG card, shown in the rtrv-card output in
Step
1.
910-6278-001 Revision A, January 2012
Removing an IPSG Card
Removing an IPSG Linkset
Removing an IP Host Assigned to an IPSG Card
Removing an IP Route
Removing an IPSG Association
EAGLE5 41.0.0
APPL
LSET NAME
VSCCP
GLS
STPLAN
EOAM
EOAM
SS7ANSI
lsn1
SS7ANSI
lsn2
ATMANSI
atmgwy
IPSG
ipsgnode1
IPSG
ipsgnode2
IPLIM
ipnode1
IPLIM
ipnode4
IPSG M2PA and M3UA Configuration Procedures
procedure
procedure
procedure
procedure
Removing an IPSG M2PA Signaling Link
Removing an IPSG M3UA Signaling Link
LINK SLC LSET NAME
A
0
lsn2
A
0
lsn1
A
0
A
0
ipsgnode1
A
0
A
0
ipnode3
A
0
procedure
procedure
procedure
LINK SLC
B
1
B
1
B
1
B
0
809
Need help?
Do you have a question about the IP7 Secure Gateway and is the answer not in the manual?
Questions and answers