Tekelec IP7 Secure Gateway Administration Manual page 502

Database Administration Manual - IP7 Secure
Gateway
ASNAMES
as7
IP Appl Sock table is (8 of 4000) 1% full
Assoc Buffer Space Used (16 KB of 800 KB) on LOC = 1203
Repeat this step for all the associations shown in
5. Change the open parameter value of the association to no by using the chg-assoc command.
Note: If the open parameter value of all the associations shown in
procedure with
For example, enter these commands.
chg-assoc:aname=assoc1:open=no
chg-assoc:aname=assoc15:open=no
When this command has successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:18:37 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD
CAUTION: The IP connections using the associations specified in this step will not
be able to carry any traffic when the open parameter is changed to no.
Repeat this step for all the associations shown in
6. Remove the routing key information from the database by entering the dlt-appl-rtkey command.
The parameters required for the dlt-appl-rtkey command are determined by the type of routing
key being added and the service indicator value in the routing key. See
Parameter Combinations for Removing Routing Keys
for the type of routing key being added to the database. For example, enter these commands.
dlt-appl-rtkey:dpci=6-006-6:si=3:ssn=170:asname=as2
dlt-appl-rtkey:rcontext=225
When each of these commands have successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
DLT-APPL-RTKEY: MASP A - COMPLTD
7. Verify the changes by entering the rtrv-appl-rtkey command with the routing key parameters
Step 6
specified in
For this example, enter these commands.
rtrv-appl-rtkey:dpci=6-006-6:si=3:ssn=170:asname=as2
The following is an example of the possible output.
rlghncxa03w 08-04-28 21:15:37 GMT EAGLE5 38.0.0
No matching entries found
STATIC Route Key table is (12 of 2000) 1% full
STATIC Route Key Socket Association table is (6 of 32000) 1% full
rtrv-appl-rtkey:rcontext=225
910-6278-001 Revision A, January 2012
Step 6.
(dpc, si, opc, cics, cice, ssn, asname, and type , and loc , as applicable).
IETF M3UA and SUA Configuration Procedures
Step 2 or Step 3.
Step 4
Step 4 that contain the open=yes parameter value.
for the parameter combinations that can be used
is no, continue the
Table 35: Routing Key
502