Tekelec IP7 Secure Gateway Administration Manual page 189

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-assoc
command.
Are only the
open, alw, or rtxthr
parameter values being
changed?
Yes
Is the
open parameter value
being changed to yes?
(See the Note)
Yes
Is a signaling
link assigned to the card,
shown in the LSET NAME and
LINK columns in the
rtrv-card output?
No
Perform the "Adding an
IPLIMx Signaling Link"
procedure in this chapter
to add the required
signaling link.
Sheet 1 of 4
910-6278-001 Revision A, January 2012
Enter the rtrv-card command
with this parameter.
:loc = <the location of the card
containing the association that will be
changed, shown in the rtrv-assoc
output>
Is the IPSG
No
application is assigned
to the card?
No
To
Sheet 2
Is the rtxthr
parameter value being
changed?
No
No
Yes
To
Sheet 7x
IETF M2PA Configuration Procedures
Note: If the open parameter value is being
changed to yes, the association must
contain values for the lhost, lport, rhost, and
rport parameters. A signaling link containing
the loc and link value that is assigned to the
association must be provisioned in the
database.
Perform the "Changing the
Attributes of an IPSG
Yes
Association" procedure in
Chapter 14 to change the
attributes of the association.
Enter the
rtrv-assoc command with this
Yes
parameter.
:aname=<name of the association
name being changed>
Enter the chg-assoc with this
mandatory parameter:
:aname=<name of the association
being changed>
and with at least one of these optional
parameters.
:alw = <yes, no>
:open = <yes, no>
:rtxthr = < 0
Enter the
rtrv-assoc command with this
parameter.
:aname=<association name specified
with the chg-assoc command>
Enter the
chg-db:action=backup:dest=fixed
command.
65535>
189