Tekelec IP7 Secure Gateway Administration Manual page 717

Database Administration Manual - IP7 Secure
Gateway
CURRENT TEMPERATURE
PEAK TEMPERATURE:
SIGNALING LINK STATUS
SLK
A
Command Completed
If the defrouter parameter will be specified in
If the defrouter parameter will not be specified in
one of these steps.
If the sctpcsum parameter value for the card will not be changed, continue the procedure with
Step 11.
If the sctpcsum parameter value for the card will be changed, continue the procedure with
Step 10.
9. Verify that the IP address of either Ethernet A or B (the address whose network portion matches
the network portion of the defrouter parameter value to be used in
by entering the rtrv-ip-lnk command with the card location specified in this procedure.
For this example, enter this command.
rtrv-ip-lnk:loc=1201
The following is an example of the possible output.
rlghncxa03w 06-10-28 21:17:37 GMT EAGLE5 36.0.0
LOC PORT IPADDR
1201 A 192.1.1.10
1201 B --------------- --------------- ----
If the network portion of the IP address specified by the defrouter value does not match the
network portions of either IP address displayed in this step, perform one of these actions:
Choose another value for the defrouter parameter, making sure that the network portion of
the new IP address matches the network portion of one of the IP addresses displayed in this
step.
Perform the
step so that the network portion of the new IP address changed in the
procedure matches the network portion of the IP address value for the defrouter parameter.
After this step has been completed, continue the procedure by performing one of these steps.
If the sctpcsum parameter value for the card will not be changed, continue the procedure with
Step 11.
If the sctpcsum parameter value for the card will be changed, continue the procedure with
Step 11.
10. To change the sctpcsum parameter value for the IP card, the sctpcsum parameter value in the
rtrv-sg-opts output must be percard. Verify the sctpcsum parameter value by entering the
rtrv-sg-opts command.
The following is an example of the possible output.
rlghncxa03w 08-04-13 09:19:43 GMT EAGLE5 38.0.0
SRKQ:
SNMPCONT:
910-6278-001 Revision A, January 2012
= 32C ( 90F)
= 39C (103F)
PST
IS-NR
SUBMASK
255.255.255.0
Configuring an IP Link procedure and change one of the IP addresses shown in this
1500
tekelec
IPSG M2PA and M3UA Configuration Procedures
[ALARM TEMP:
[06-05-02 13:40]
LS CLLI
nc001 -----------
Step 11, continue the procedure with
Step 11, continue the procedure by performing
DUPLEX
----
60C (140F)]
Step 11) is in the IP link table
SPEED MACTYPE AUTO MCAST
--- DIX YES
--- DIX YES
Configuring an IP Link
Step 11.
NO
NO
717