Tekelec IP7 Secure Gateway Administration Manual page 836

Database Administration Manual - IP7 Secure
Gateway
This is an example of possible output.
rlghncxa03w 08-03-06 15:17:20 EST EAGLE5 38.0.0
CARD TYPE
1201 ENET
rtrv-card:loc=1203
This is an example of possible output.
rlghncxa03w 08-03-06 15:17:20 EST EAGLE5 38.0.0
CARD TYPE
1203 ENET
If the application assigned to the card is IPSG, shown in the APPL column, and signaling links are
not assigned to the card, continue the procedure with
If the application assigned to the card is IPSG, shown in the APPL column, and signaling links are
assigned to the card, perform one of these procedures depending on the ADAPTER value that is
assigned to the association that will be removed.
If the ADAPTER value is M2PA, perform the
If the ADAPTER value is M3UA, perform the
After the signaling links have been removed from the card, continue the procedure with
If the application assigned to the card is IPLIM or IPLIMI, perform the
procedure.
If the application assigned to the card is SS7IPGW or IPGWI, perform the
SUA Association
3. Change the value of the open parameter to no by specifying the chg-assoc command with the
open=no parameter.
Note: If the value of the open parameter for the association being removed from the database
(shown in Step
For this example, enter these commands.
chg-assoc:aname=assoc1:open=no
chg-assoc:aname=swbel32:open=no
When the chg-assoc command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
4. Remove the association from the database using the dlt-assoc command.
For this example, enter these commands.
dlt-assoc:aname=assoc1
dlt-assoc:aname=swbel32
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
DLT-ASSOC:
910-6278-001 Revision A, January 2012
APPL LSET NAME
IPSG lsn2
APPL LSET NAME
IPSG lsn1
procedure.
1) is no, continue this procedure with
MASP A - COMPLTD
IPSG M2PA and M3UA Configuration Procedures
LINK SLC LSET NAME
A 0
LINK SLC LSET NAME
A1 0
Step 3.
Removing an IPSG M2PA Signaling Link
Removing an IPSG M3UA Signaling Link
Step 4.
LINK SLC
LINK SLC
procedure.
procedure.
Step
Removing an M2PA Association
Removing a M3UA or
3.
836