Tekelec IP7 Secure Gateway Administration Manual page 916

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 5
:link=<link value for the signaling link>
Repeat this step for each signaling link
shown in the rtrv-ls output on Sheet 1.
rtrv-slk command with this parameter.
:aname=<the name of the association
Repeat this step for each association
shown in the rtrv-ls output on Sheet 1.
Sheet 6 of 8
910-6278-001 Revision A, January 2012
What type
IPSG M2PA
of linkset was
Linkset
selected when this
procedure was
started?
IPSG M3UA
Linkset
Do you wish
Yes
to remove the
RCONTEXT value from
the linkset?
No
Are signaling
No
links assigned to the
linkset?
Yes
Enter the
dact-slk command with these
parameters.
:loc=<IPSG card location>
Enter the
assigned to the signaling link in the
linkset>
Enter the rtrv-ls command with this
parameter.
:lsn=<the name of the linkset
shown in the rtrv-slk output>
Repeat this step for each linkset
shown in the rtrv-slk output.
IPSG M2PA and M3UA Configuration Procedures
To
Sheet 8
The new RCONTEXT value for the
linkset that is being changed
cannot be the same as any
RCONTEXT values shown in the
rtrv-ls output in the previous step.
To
Sheet 7
916