Tekelec IP7 Secure Gateway Administration Manual page 405

Database Administration Manual - IP7 Secure
Gateway
7. Display the signaling link assigned to the card, shown in
the local host shown in
signaling link. For this example, enter this command.
rtrv-slk:loc=1205
The following is an example of the possible output.
rlghncxa03w 06-10-28 21:19:37 GMT EAGLE5 36.0.0
LOC LINK LSN
1205 A lsn5
The application running on the card is shown in the TYPE column of the rtrv-slk output.
For this example, the new association must be assigned to a card running the SS7IPGW application.
If the card's application shown in this step and in
Step 8.
If the card's application shown in this step and in
from Step 5 with another local IP host, or add the new local IP host name by performing the
an IP Host procedure. The new local IP host must be assigned to a card running the application
shown in Step
8. Display the associations assigned to the local IP host value specified in
the rtrv-assoc command with the lhost parameter. For this example, enter this command.
rtrv-assoc:lhost="IPNODE-1205"
This is an example of the possible output.
rlghncxa03w 06-10-28 21:14:37 GMT EAGLE5 36.0.0
ANAME
assoc1
IP Appl Sock/Assoc table is (7 of 4000) 1% full
Assoc Buffer Space Used (16 KB of 3200 KB) on LOC = 1205
9. Display the application servers that the associations shown in
rtrv-as command with the names of the associations shown in
this command.
rtrv-as:aname=assoc1
This is an example of the possible output.
rlghncxa03w 06-10-28 21:14:37 GMT EAGLE5 36.0.0
AS Name
as1
AS Table is (2 of 250) 1% full
The maximum number of SCTP association to application server assignments that can be hosted
by an IPGWx card (referenced by the lhost parameter of the association) is 50.
If the number of SCTP association to application server assignments is less than 50, continue the
procedure with
If the number of SCTP association to application server assignments is 50, either repeat this
procedure from
the Adding an IP Host
910-6278-001 Revision A, January 2012
Step 5 by entering the rtrv-slk command with the card location of the
SLC TYPE
1 SS7IPGW
4. After the new local IP host has been added, continue the procedure with
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1205 A A
Mode Tr ms
LOADSHARE 10
Step 10.
Step 5 with another local IP host, or add the new local IP host name by performing
procedure. The new local IP host must be assigned to a card running the
IETF M3UA and SUA Configuration Procedures
Step
Step 4 are the same, continue the procedure with
Step 4 are not the same, either repeat this procedure
M3UA 1030 1030
Association Names
assoc1
6, whose IP address is assigned to
Step 3 or Step 5
YES YES
Step 8 are assigned to by entering
Step 8. For this example, enter
Adding
Step 9.
by entering
405