Tekelec IP7 Secure Gateway Administration Manual page 935

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 3
Note: The m2patset
parameter can be
specified only for IPSG
M2PA associations .
Yes
Enter the
rtrv-uaps command.
Is the desired
UA parameter set
defined with the desired
values?
No
Perform the "Changing a UA
Parameter Set" procedure in
this chapter and change the
desired UA parameter set with
the desired values.
Caution: Changing a UA
parameter set may affect the
performance of any
associations using the UA
parameter set being changed.
Enter the chg-assoc command
with these parameters.
:aname=<name of the
association being changed>
:rhost = <remote host name>
The rhosttype=primary
parameter can be specified
with the rhost parameter, but it
is not necessary.
Sheet 4 of 5
910-6278-001 Revision A, January 2012
Is the
m2patset parameter
Yes
to be specified with the
chg-assoc command?
See the Note.
No
Is the uaps
parameter to be specified
with the chg-assoc
command?
No
Is a remote
Yes
host value being
changed?
Is the alternate
remote host value being
changed?
Is a value
No
shown in the RHOST
field of the rtrv-assoc
output?
Specify the rhost and rhosttype=primary
parameters with the chg-assoc command
on Sheet 8x. This will change the alternate
remote host value, shown in the ARHOST
field of the rtrv-assoc output.
IPSG M2PA and M3UA Configuration Procedures
Enter the rtrv-m2pa-tset command
with one of these parameters.
:ver=d6 – to display the Draft 6
version of the M2PA timer set
:ver=rfc – to display the RFC version
of the M2PA timer set
If neither parameter is specified with
the rtrv-m2pa-tset command, both
versions of the M2PA timer set are
displayed.
Yes
To
Sheet 5
No
Yes
Specify the rhost parameter
with the chg-assoc command
on Sheet 5. This will change
the primary remote host value,
No
shown in the RHOST field of
the rtrv-assoc output. The
rhosttype=primary parameter
can be specified with the rhost
parameter, but it is not
Yes
Yes
Is the desired
M2PA timer set
defined with the desired
values?
No
Perform the "Changing an M2PA
Timer Set" procedure in this
chapter and change the desired
timer set with the desired values.
Caution: Changing an M2PA
timer set may affect the
performance of any associations
using the timer set being
changed.
necessary.
To
Sheet 5
935