Tekelec IP7 Secure Gateway Administration Manual page 402

Database Administration Manual - IP7 Secure
Gateway
M2PA associations (adapter=m2pa) cannot be assigned to application servers. Only M3UA
(adapter=m3ua) and SUA (adapter=sua) associations can be assigned to application servers. This
can be verified in the ADAPTER field in the rtrv-assoc output.
The application running on the card hosting the association that will be assigned to the application
server must be the same as the application running on the cards hosting the other associations assigned
to the application server.
Canceling the RTRV-AS and RTRV-ASSOC Commands
Because the rtrv-as and rtrv-assoc commands used in this procedure can output information
for a long period of time, the rtrv-as and rtrv-assoc commands can be canceled and the output
to the terminal stopped. There are three ways that the rtrv-as and rtrv-assoc commands can be
canceled.
Press the F9 function key on the keyboard at the terminal where the rtrv-as or rtrv-assoc
commands were entered.
Enter the canc-cmd without the trm parameter at the terminal where the rtrv-as or rtrv-assoc
commands were entered.
Enter the canc-cmd:trm=<xx>, where <xx> is the terminal where the rtrv-as or rtrv-assoc
commands were entered, from another terminal other that the terminal where the rtrv-as or
rtrv-assoc commands were entered. To enter the canc-cmd:trm=<xx> command, the terminal
must allow Security Administration commands to be entered from it and the user must be allowed
to enter Security Administration commands. The terminal's permissions can be verified with the
rtrv-secu-trm command. The user's permissions can be verified with the rtrv-user or
rtrv-secu-user commands.
For more information about the canc-cmd command, go to the Commands Manual.
1. Display the application servers in the database using the rtrv-as command.
This is an example of possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
AS Name
as1
as2
AS table is (2 of 250) 1% full.
2. Display the application server that the new association will be added to by entering the rtrv-as
command with the name of the application server.
For this example, enter this command.
rtrv-as:asname=as2
This is an example of possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
AS Name
as2
910-6278-001 Revision A, January 2012
Mode Tr ms
LOADSHARE 10
OVERRIDE 10
Mode Tr ms
OVERRIDE 10
IETF M3UA and SUA Configuration Procedures
Association Names
assoc1
assoc2
assoc3
assoc5
assoc6
assoc7
Association Names
assoc7
402