Tekelec IP7 Secure Gateway Administration Manual page 686

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-ls
command.
The APC of this linkset
cannot be shown in the
rtrv-ls output.
Enter the rtrv-sid
command.
Is the PRX=YES
parameter value shown in
the previous step?
Yes
This point code cannot be
used as the APC of this
linkset. Choose another
point code.
Do you wish to
Yes
choose another APC
for the linkset?
No
Perform the Removing a
Route" procedure in the
Database Administration
Manual - SS7 to remove all the
entries shown in the rtrv-rte
output
Sheet 1 of 5
910-6278-001 Revision A, January 2012
Enter the rtrv-dstn
command.
linkset being added in
this procedure in the
Enter the rtrv-dstn
command with this
parameter.
:dpc/dpca/dpci/dpcn/
dpcn24=<APC value for
the linkset being added>
Is a proxy point
No
code assigned to the
point code displayed in
the previous step?
Do you wish to
Yes
choose another APC
for the linkset?
Perform the Removing a
Route Exception Entry"
procedure in the Database
Administration Manual - SS7 to
remove all the entries shown in
the rtrv-rtx output
new APC of the linkset
Yes
being changed in this
procedure in the rtrv-rte
output as the DPC of
To
Sheet 2
IPSG M2PA and M3UA Configuration Procedures
Perform the Adding a
Destination Point Code"
Is the
required point code to the
APC of the
No
The PRX=YES parameter
rtrv-dstn
cannot be specified for this
output?
point code and a proxy
assigned to this point code.
Yes
Enter the rtrv-rtx command
No
dpcn24=<New APC for the
Yes
Yes
APC of the linkset being
added in this procedure in
No
Enter the rtrv-rte command with
this parameter.
:dpc/dpca/dpci/dpcn/dpcn24=<New
APC for the linkset>
Is the
a route?
No
procedure to add the
database.
point code cannot be
To
Sheet 2
with this parameter.
:dpc/dpca/dpci/dpcn/
linkset>
Is the
No
the rtrv-rtx output?
686