Tekelec IP7 Secure Gateway Administration Manual page 516

Database Administration Manual - IP7 Secure
Gateway
This is an example of possible output.
rlghncxa03w 08-04-25 14:02:39 EST
rtrv-slk:loc=1101
Command entered at terminal #4.
LOC LINK LSN
1205 A e5e6a
If a signaling link is shown in this step, perform one of these actions.
If only the alw parameter is being specified with the open=yes parameter, continue the
procedure with
If the value of the rtxthr parameter is being changed, continue the procedure with
If a signaling link is not shown in this step, perform
IPGWx signaling link to the card. After the signaling link has been added, perform one of these
actions.
If only the alw parameter is being specified with the open=yes parameter, continue the
procedure with
If the value of the rtxthr parameter is being changed, continue the procedure with
5. Change the value of the open parameter to no by specifying the chg-assoc command with the
open=no parameter.
For this example, enter this command.
chg-assoc:aname=assoc2:open=no
When this command has successfully completed, this message should appear.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
CHG-ASSOC: MASP A - COMPLTD;
6. Display the association being changed by entering the rtrv-assoc command with the aname
parameter specified in
For this example, enter this command.
rtrv-assoc:aname=assoc2
This is an example of the possible output.
rlghncxa03w 09-05-28 21:14:37 GMT EAGLE5 41.0.0
ANAME assoc2
LOC
ADAPTER
LHOST
ALHOST
RHOST
ARHOST
LPORT
ISTRMS
RMODE
RTIMES
OPEN
RHOSTVAL RELAXED
ASNAMES
as1
910-6278-001 Revision A, January 2012
SLC TYPE
0 SS7IPGW
Step 12.
Step 12.
Step 5 or selected in
1205 IPLNK PORT
M3UA VER
IPNODE2-1205
---
remotehost1
---
2048 RPORT
2 OSTRMS
LIN RMIN
10 CWMIN
No ALW
as4
IETF M3UA and SUA Configuration Procedures
38.0.0
Adding an IPGWx Signaling Link
Step 1.
A LINK
M3UA RFC
2048
2 BUFSIZE
120 RMAX
3000 UAPS
YES RTXTHR
as6
Step 6.
to assign an
Step 6.
A
200
800
10
2000
516