Tekelec IP7 Secure Gateway Administration Manual page 526

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 4
Is the uaps
parameter to be specified
with the chg-assoc
command?
Enter the
rtrv-uaps command
Is the desired
UA parameter set
defined with the desired
values?
(See Note 1)
Perform the "Changing a UA
Parameter Set" procedure in
this chapter and change the
desired UA parameter set with
the desired values (See
Caution)
To
Sheet 6
Sheet 5 of 8
910-6278-001 Revision A, January 2012
Note 1. If the uaps parameter will not be
specified with the chg-assoc command, and the
adapter parameter value is being changed to
either m3ua or sua, the UA parameter set 10
will be assigned to the association.
Caution: Changing a UA parameter set may
affect the performance of any associations
using the UA parameter set being changed.
Note 2. The cwmin value must be less than or
No
equal to the bufsize value.
The cwmin value is the number of bytes
specified for the size of the association's
congestion window. The bufsize value is the
number of kilobytes specified for the size of the
association's buffer .
Yes
To determine whether or not the cwmin value is
less than or equal to the bufsize value, perform
one of these actions:
Multiply the bufsize value by 1024
Divide the cwmin value by 1024.
Yes
parameter to be
specified with the
No
Is the new cwmin
Yes
value less than or equal to
the bufsize parameter value?
(See Note 2)
Either choose another value for
the cwmin parameter that is less
than or equal to the bufsize
value, or change the bufsize
value by performing the
Changing the Buffer Size of an
M2PA Association" procedure in
IETF M3UA and SUA Configuration Procedures
Is the cwmin
No
chg-assoc
command?
Yes
To
Sheet 6
No
this chapter.
526