Tekelec IP7 Secure Gateway Administration Manual page 740

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
Notes:
1. The IP address of the IP link should be
assigned to the host name, shown in the
rtrv-ip-host output, that will be assigned to the
association.
2. The values of the lhost and alhost parameters
must be in the LOCAL HOST column in the
rtrv-ip-host output.
3: If the m2patset parameter will not be specified
with the ent-assoc command, the RFC version of
M2PA timer set 1 will be assigned to the
association.
Caution: Changing an M2PA timer set may
affect the performance of any associations using
the timer set being changed.
Sheet 2 of 4
910-6278-001 Revision A, January 2012
Enter the
rtrv-ip-lnk command.
Is the required
No
IP link in the IP Link
table?
Yes
Enter the
rtrv-ip-host command with
this parameter.
:display=all
Is the required
No
host name shown in the
rtrv-ip-host output? See
Notes 1 and 2.
Yes
IPSG M2PA and M3UA Configuration Procedures
Perform the "Configuring
an IP Link" procedure in
this chapter to add the
required IP link.
Perform the "Adding an IP
Host" procedure in this
chapter and add the
required host name.
Enter the
rtrv-m2pa-tset command.
Is the desired
M2PA timer set
defined with the desired
values? See
Note 3.
No
Perform the "Changing an
M2PA Timer Set " procedure in
this chapter to change the
desired timer set with the
desired values. See the
Caution.
Yes
To
Sheet 3
740