Tekelec IP7 Secure Gateway Administration Manual page 929

Database Administration Manual - IP7 Secure
Gateway
If the rhost parameter will be specified for the association, continue the procedure with
8.
If the uaps or rhost parameter will not be specified for the association, continue the procedure
with Step 10.
8. The remote hosts assigned to the association can be changed by specifying the rhost and
rhosttype parameters with the chg-assoc command.
If the primary and alternate remote hosts are not being changed in this procedure, or if only the
primary remote host is being changed, continue the procedure with
To change the alternate remote host value for the association, the association must have a primary
remote host assigned to it. If the association has a primary remote host, continue the procedure
with Step 10. If the association does not have a primary remote host, continue the procedure with
Step 9.
9. Assign a primary remote host to the association by entering the chg-assoc command with the name
of the association and the primary remote host name.
For this example, enter this command.
chg-assoc:aname=assoc2:rhost= gw200.nc-tekelec.com
The rhosttype=primary parameter can be specified with the chg-assoc command, but is not
necessary.
When this command has successfully completed, this message should appear.
rlghncxa03w 09-05-28 09:12:36 GMT EAGLE5 41.0.0
CHG-ASSOC: MASP A - COMPLTD;
10. Change the association using the chg-assoc command.
For this example, enter these commands.
chg-assoc:aname=assoc2:rhost= gw200.nc-tekelec.com
:rport=3000:rtxthr=10000:rhostval=match
chg-assoc:aname=assoc1:rport=3000:rtxthr=10000:uaps=3:rhostval=match
If an alternate remote host is being specified for the association, for this example enter this command.
chg-assoc:aname=assoc2:rhost= gw210.nc-tekelec.com :rhosttype=alternate
:rport=3000:rtxthr=10000:rhostval=match
Note: The m2patset and ver parameters can be specified only for M2PA associations.
If only the alw, open, rtxthr parameter values are being changed in this step, for this example,
enter this command.
Note: If the adapter parameter value for the association is M3UA, the alw parameter cannot be
specified.
chg-assoc:aname=assoc2:alw=no:open=yes:rtxthr=10000
These are the rules that apply to changing the attributes of an IPSG association.
1. If any optional parameters are not specified with the chg-assoc command, those values are
not changed.
2. The value of the rhost parameter is a text string of up to 60 characters, with the first character
being a letter. The command input is limited to 150 characters, including the hostname.
910-6278-001 Revision A, January 2012
IPSG M2PA and M3UA Configuration Procedures
Step 10.
Step
929