Tekelec IP7 Secure Gateway Administration Manual page 888

Database Administration Manual - IP7 Secure
Gateway
Some ATM high-speed signaling links have to be removed. To perform this action, continue
the procedure with
If you do not wish to perform other actions to increase the available TPS and the available TPS will
allow the IPSG M2PA linkset to be changed, continue the procedure with
10. Reduce the MAX SLKTPS, and RSVDSLKTPS value if necessary, for the linksets displayed in
9 by entering the chg-ls command with the new maxslktps and rsvdslktps values. For this
example, enter these commands.
chg-ls:lsn=ipsglsn:maxslktps=3000
chg-ls:lsn=ipsglsn2:maxslktps=3000
Note: The rsvdslktps value must be less than or equal to the maxslktps value.
When this command has successfully completed, this message should appear.
rlghncxa03w 10-07-17 16:23:21 GMT
Link set table is ( 13 of 1024)
CHG-LS: MASP A - COMPLTD
11. Change the linkset by entering the chg-ls command with the name of the linkset and at least one
of these optional parameters and values.
rsvdslktps = 100 - 5000
maxslktps = 0 - 5000
tpsalmtype = rsvdslktps or maxslktps
lsusealm = 10 - 100
slkusealm = 10 - 100
For this example, enter this command.
chg-ls:lsn=lssg1101:rsvdslktps=500:maxslktps=3000:tpsalmtype=maxslktps
:lsusealm=60:slkusealm=70
Note: The rsvdslktps value must be less than or equal to the maxslktps value.
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-17 16:23:21 GMT
Link set table is ( 13 of 1024)
CHG-LS: MASP A - COMPLTD
Note: There are other optional parameters that can be specified with the chg-ls command, but
are not required for an IPSG M2PA linkset. These parameters and their usage are discussed in the
Other Optional Parameters section of this procedure.
12. Verify the changes using the rtrv-ls command specifying the linkset name specified in
For this example, enter this command.
rtrv-ls:lsn=lssg1101
This is an example of the possible output.
rlghncxa03w 10-07-20 13:34:40 GMT
910-6278-001 Revision A, January 2012
IPSG M2PA and M3UA Configuration Procedures
Step 6.
EAGLE5 42.0.0
1% full
EAGLE5 37.5.0
1% full
EAGLE5 42.0.0
Step 11.
Step
Step 11.
888