Adding An Ipsg M3Ua Association; Table 53: Ipsg M3Ua Association Fields And Default Values - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway

Adding an IPSG M3UA Association

This procedure is used to configure IPSG M3UA associations using the ent-assoc command. The
combination of a local host, local SCTP port, remote host and remote SCTP port defines an association.
IPSG M3UA associations are assigned to E5-ENET cards running the IPSG application (IPSG cards).
The ent-assoc command uses these parameters to add an IPSG M3UA association to the database.
:aname – The name assigned to the association. Valid association names can contain up to 15
alphanumeric characters where the first character is a letter and the remaining characters are
alphanumeric characters. The aname parameter value is not case-sensitive.
:lhost – Local Hostname. The logical name assigned to the local host device.
:lport – The SCTP port number for the local host.
:rhost – Remote Hostname. The logical name assigned to the remote host device.
:rport – The SCTP port number for the remote host.
:adapter – The adapter layer for this association, m3ua. The adapter parameter is required for
adding an IPSG M3UA association. The default value for the adapter parameter is m2pa.
:alhost – The alternate local host name.
The link parameter cannot be specified for an IPSG M3UA association.
The adapter=m2pa and m2patset parameters can be used only when configuring M2PA associations.
Perform the Adding an M2PA Association
M2PA associations.
Associations contain fields whose values are not assigned using the ent-assoc command. When an
association is added to the database, these fields receive their default values. If a different value is
desired, the chg-assoc command must be used. To change these values perform the
Attributes of an IPSG Association
These fields and their default values are shown in
Values.

Table 53: IPSG M3UA Association Fields and Default Values

open=no
istrms=2
bufsize=16
An IPSG M3UA association can contain an alternate remote host. The alternate remote host is
provisioned with the rhost and rhostype=alternate parameters of the chg-assoc command.
A primary remote host can be provisioned on this procedure by specifying the rhost parameter with
the ent-assoc command. To provision an alternate remote host for an IPSG M3UA association,
perform Changing the Attributes of an IPSG
The size of the buffers on the IPSG cards is 3200 KB. The size of the buffers assigned to each association
that is assigned to the IPSG card cannot exceed the maximum buffer size for the IPSG card. When a
910-6278-001 Revision A, January 2012
or
procedure.
rmax=800 cwmin=3000
rmode=lin rtimes=10
rtxthr=0 rhostval=relaxed
IPSG M2PA and M3UA Configuration Procedures
Adding an IPSG M2PA Association
Table 53: IPSG M3UA Association Fields and Default
alw=no
ostrms=2
Association.
procedures to configure
Changing the
uaps=10
rmin=120
743