Figure 110: Removing An Ipsg M3Ua Signaling Link - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 2
Is the signaling
link the last signaling
link on the card?
No
Sheet 3 of 3

Figure 110: Removing an IPSG M3UA Signaling Link

910-6278-001 Revision A, January 2012
Enter the rmv-card command with
Yes
this parameter.
:loc=<location of the signaling link>
Enter the rept-stat-card command
with this parameter.
:loc=<location of the signaling link>
Is the signaling
link the last signaling
link in the linkset?
No
Enter the dlt-slk command with
these parameters.
:loc=<location of the signaling link>
:link=<signaling link being
removed>
See the Note.
Enter the rtrv-slk command with these
parameters.
:loc=<location specified in the dlt-slk
command>
:link=<signaling link specified in the dlt-slk
command>
Enter the
chg-db:action=backup:dest=fixed
command.
IPSG M2PA and M3UA Configuration Procedures
Note: If removing the signaling link
will result in 700 or less signaling
links in the database and the
OAMHCMEAS value in the
rtrv-measopts output is on, the
scheduled UI measurement reports
will be enabled.
Enter the dlt-slk command with
these parameters.
:loc=<location of the signaling link>
Yes
:link=<signaling link being
removed>
:force=yes
See the Note.
855