Tekelec IP7 Secure Gateway Administration Manual page 745

Database Administration Manual - IP7 Secure
Gateway
command. The user's permissions can be verified with the rtrv-user or rtrv-secu-user
commands.
For more information about the canc-cmd command, go to the Commands Manual.
1. Display the associations in the database using the rtrv-assoc command. This is an example of
possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
ANAME
swbel32
a2
a3
assoc3
Perform one of these actions.
If the desired IP link (shown by the entries in the CARD LOC and IPLNK PORT columns for an
association whose ADAPTER value is M3UA) is shown in the rtrv-assoc output, continue the
procedure with
If the desired IP link is not shown in the rtrv-assoc output, continue the procedure with
4.
2. Display the card that the new M3UA association will be assigned to by entering the rtrv-card
command with the card location displayed in
rtrv-card:loc=1201
The following is an example of the possible output.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
CARD TYPE
1201 ENET
If the value in the TYPE column is IPSG, continue the procedure with
If the value in the TYPE column is either SS7IPGW or IPGWI, the host assigned to this card cannot
be used in this procedure. If you wish to use this card to configure an M3UA association, perform
the Adding an M3UA or SUA Association
If you do not wish to use this card to configure an M3UA association, perform one of these actions.
Choose another card from the rtrv-assoc output in
Continue the procedure with
M3UA association.
3. Display the associations assigned to the card that the new association will be assigned to by entering
the rtrv-assoc command with the card location specified in
command.
rtrv-assoc:loc=1203
The following is an example of the possible output.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
ANAME
swbel32
910-6278-001 Revision A, January 2012
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A M3UA
1305 A A SUA
1307 A A SUA
1203 A A1 M2PA
Step 2.
APPL LSET NAME
IPSG m3ua1
procedure.
Step 4 to choose another IPSG card and IP link for the new IPSG
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A M3UA
IPSG M2PA and M3UA Configuration Procedures
1030 2345 YES
1030 2345 YES
1030 2346 YES
2048 1030 NO
Step 1. For this example, enter this command.
LINK SLC LSET NAME
A 0
Step 1 and repeat this step.
Step 2. For this example, enter this
1030 2345 YES
YES
YES
YES
NO
LINK SLC
Step 3.
YES
Step
745