Tekelec IP7 Secure Gateway Administration Manual page 862

Database Administration Manual - IP7 Secure
Gateway
Link set table is (25 of 1024) 2% full.
When the chg-card command is executed, the RSVDSLKTPS and MAXSLKTPS values of the linkset
will be assigned based on the current IPSG value of the linkset.
If the current IPSG value of the linkset is no, the RSVDSLKTPS value of the linkset will be 0 (zero)
and the MAXSLKTPS value of the linkset will be 4000.
If the current IPSG value of the linkset is yes, the RSVDSLKTPS and the MAXSLKTPS values will
not be changed. The total TPS used by the signaling links in this linkset will be the number of
signaling links in the linkset multiplied by the RSVDSLKTPS value of the linkset.
6. Display the associations that are assigned to the card by entering the rtrv-assoc command with
the card location of the card that is being changed.
For this example, enter this command.
rtrv-assoc:loc=1303
This is an example of possible output.
rlghncxa03w 10-07-17 11:43:04 GMT EAGLE5 42.0.0
ANAME
iplim1
iplim2
IP Appl Sock/Assoc (
Assoc Buffer Space Used (400 KB of 3200 KB) on LOC = 1303
If M2PA associations are not shown in the rtrv-assoc output, perform the
Association procedure to add M2PA associations to the card.
If M2PA associations are shown in the rtrv-assoc output, or after the M2PA associations have
been added in this step, continue the procedure by performing one of these actions.
If the current IPSG value of all the linksets shown in
Step 7.
If the current IPSG value of all the linksets shown in
TPS value (5000) will not be exceeded when the chg-card command is executed, continue the
procedure with
If the current IPSG value of any of the linksets shown in
TPS value (5000) will be exceeded when the chg-card command is executed, perform the
Changing an IPSG M2PA Linkset
value if necessary, of each IPSG linkset shown in the rept-stat-card output in
required. After the linksets have been changed, continue the procedure with
7. Display the total provisioned system TPS by entering the rtrv-tps command. This is an example
of the possible output.
rlghncxa03w 10-07-10 16:20:46 GMT
CARD NUM
TYPE CARDS
----- -----
IPGW 17
IPSG 4
IPLIM 2
ATM 2
910-6278-001 Revision A, January 2012
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1303 A A
1303 A B
19 of 4000) 1%
Step 7.
procedure to change the RSVDSLKTPS value, and the MAXSLKTPS
NUM RSVD
LINKS TPS
----- -------- --------
16 48000
8 4700
4 8000
2 3668
IPSG M2PA and M3UA Configuration Procedures
M2PA 2000 2000
M2PA 3000 2000
Step 5 is no, continue the procedure with
Step 5 is yes, and the card's maximum
Step 5
EAGLE 42.0.0
MAX
TPS
80000
12000
8000
3668
YES YES
YES YES
Adding an M2PA
is yes, and the card's maximum
Step 2
Step 7.
as
862