Tekelec IP7 Secure Gateway Administration Manual page 197

Database Administration Manual - IP7 Secure
Gateway
RTIMES
OPEN
RHOSTVAL RELAXED
IP Appl Sock/Assoc table is (8 of 4000) 1% full
Assoc Buffer Space Used (1600 KB of 1600 KB) on LOC = 1205
7. To change the bufsize value for the associations shown in
value must be greater than or equal to the cwmin parameter value.
The cwmin parameter is the number if bytes specified for the association's congestion window.
The bufsize is the number of kilobytes specified for the size of the association's buffer. To
determine whether or not the cwmin value is less than or equal to the bufsize value, perform
one of these actions.
Multiply the bufsize value by 1024.
Divide the cwmin value by 1024.
Continue the procedure by performing one of these actions.
If the new bufsize value is greater than or equal to the cwmin value, continue the procedure
with Step 8.
If the new bufsize value is not greater than or equal to the cwmin value, either choose another
value for the bufsize parameter that is greater than or equal to the cwmin value, or perform
the Changing the Attributes of an M2PA Association
that the bufsize value is greater than or equal to the cwmin value. After the new bufsize
value has been chosen or the cwmin value has been changed, continue the procedure with
8.
8. Change the size of the buffers for one or more of the associations displayed in
buffer of the association displayed in
Enter the chg-assoc command with the bufsize parameter. For this example, enter this command.
chg-assoc:aname=assoc3:bufsize=400
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
9. To change the bufsize value for the association shown in
value must be greater than or equal to the cwmin parameter value.
The cwmin parameter is the number if bytes specified for the association's congestion window.
The bufsize is the number of kilobytes specified for the size of the association's buffer. To
determine whether or not the cwmin value is less than or equal to the bufsize value, perform
one of these actions.
Multiply the bufsize value by 1024.
Divide the cwmin value by 1024.
Continue the procedure by performing one of these actions.
If the new bufsize value is greater than or equal to the cwmin value, continue the procedure
with Step 10.
If the new bufsize value is not greater than or equal to the cwmin value, either choose another
value for the bufsize parameter that is greater than or equal to the cwmin value, or perform
910-6278-001 Revision A, January 2012
10 CWMIN
YES ALW
M2PATSET
Step 4
IETF M2PA Configuration Procedures
3000 UAPS
YES RTXTHR
1
Step 6, the new bufsize parameter
procedure to change the bufsize value so
to be changed.
Step 4, the new bufsize parameter
10
2000
Step
Step 6
to allow the
197