Changing The Attributes Of An Ipsg Association; Table 58: Change Ipsg Association Parameters - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway

Changing the Attributes of an IPSG Association

This procedure is used to change the values of the attributes of an IPSG association, assigned to cards
that are running the IPSG application, IPSG cards, using the chg-assoc command and the following
parameters.

Table 58: Change IPSG Association Parameters

aname
rmode
ostrms
rhostval
If you wish to change the attributes of M2PA associations assigned to cards that are running the IPLIM
or IPLIMI applications, perform
If you wish to change the attributes of M3UA associations assigned to cards that are running the
SS7IPGW or IPGWI applications, perform
The chg-assoc command contains other parameters that are not used in this procedure. To change
these parameters, perform these procedures.
lhost and alhost -
Changing the Buffer Size of an IPSG Association
bufsize -
:aname – The name assigned to the association, shown in the rtrv-assoc output.
:lport – The SCTP port number for the local host.
:rhost – The host name for the remote host, rhost can be any string of characters starting with a
letter and comprising these characters ['a'..'z', 'A'..'Z', '0'..'9', '-', '.']. Hostnames are not case-sensitive
and can contain up to 60 characters. The default value of this optional parameter is empty (null string).
:rport – The SCTP port number for the remote host.
:open – The connection state for this association. Valid values are yes or no. When the open=yes
parameter is specified, the connection manager opens the association if the association is operational.
When the open=no parameter is specified, the connection manager will not open the association. If
the open=no parameter is specified for an established IPSG M3UA association, and the UA Graceful
Shutdown option is enabled (refer to
M3UA connection will be gracefully shutdown.
:alw – The connection state for this association. Valid values are yes or no. When the alw=yes
parameter is specified, the connection manager allows the association to carry SS7 traffic. When the
alw=no parameter is specified, the connection manager prohibits the association from carrying SS7
traffic.
Note: If the adapter parameter value for the association is M3UA, the alw parameter cannot be
specified.
:rmode – The retransmission policy used when packet loss is detected. The values are rfc or lin.
910-6278-001 Revision A, January 2012
lport rhost
rmin rmax
m2patset ver
Changing the Attributes of an M2PA
Changing the Host Values of an IPSG
Changing a UA Parameter Set
IPSG M2PA and M3UA Configuration Procedures
rport
rtimes
rtxthr
Changing the Attributes of a M3UA or SUA
Association.
open alw
cwmin istrms
uaps rhosttype
Association.
Association.
for more information), the IPSG
919