Figure 120: Configuring An Ipsg Association For Sctp Retransmission Control - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Enter the pass:loc=<card location specified in
the previous step>:cmd="sctp -a <association
name>" command.
The association name is the association name
specified in the previous step.
Do the retransmission
parameter values need to
Sheet 2 of 2

Figure 120: Configuring an IPSG Association for SCTP Retransmission Control

910-6278-001 Revision A, January 2012
pass:loc=<card location specified with the
:cmd="assocrtt <name of the association
specified with the ping command>"
From command to display the round trip time data
Sheet 1 collected after an association is established when
an SCTP INIT message is sent and an
acknowlegement is received.
Perform this command for each association name
that references the remote host name specified in
No
be changed?
Perform the "Changing the Attributes of
Yes
an IPSG Association" procedure in this
chapter to change the retransmission
parameters based on the results of the
assocrtt (Weighted Average round -trip
time) and sctp -a (data retransmission
counts) pass command outputs
IPSG M2PA and M3UA Configuration Procedures
Enter the
ping command>
the ping command.
This procedure is
finished
977