Tekelec IP7 Secure Gateway Administration Manual page 932

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-assoc
command.
Notes:
1. If the adapter parameter value
for the association is M3UA, the
alw parameter cannot be specified.
2. If the open parameter value is
being changed to yes, the
association must contain values for
the lhost, lport, rhost, and rport
parameters. The association must
be assigned to a signaling link,
shown by the LINK value in the
rtrv-assoc output.
open parameter value
being changed to yes?
Sheet 1 of 5
910-6278-001 Revision A, January 2012
Enter the rtrv-card command
with this parameter.
:loc = <the location of the card
containing the association that will be
changed, shown in the rtrv-assoc
output>
Is the IPSG
application is assigned
to the card?
Are only the
open, alw, or rtxthr
Yes
parameter values being
changed?
(See Note 1)
Is the
Yes
(See Note 2)
No
M2PA
Perform the "Adding an
IPSG M2PA Signaling
Link" procedure in this
chapter to add the
required signaling link.
IPSG M2PA and M3UA Configuration Procedures
Perform the "Changing the
Attributes of an M2PA
Association" procedure to
change the attributes of the
No
ADAPTER value of the
Yes
Perform the "Changing the
Attributes of an M3UA or
SUA Association" procedure
to change the attributes of
No
the association.
To
Sheet 3
Is the association
Yes
assigned to a signaling
link?
No
What is the
M3UA
ADAPTER value of the
association?
Perform the "Adding an
IPSG M3UA Signaling
Link" procedure in this
chapter to add the
required signaling link.
To
Sheet 2
association.
M2PA
What is the
association?
M3UA
932