Turning Off The Large Msu Support For Ip Signaling Feature; Figure 124: Changing A Ua Parameter Set - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Enter the chg-uaps command with this mandatory
:set=< UA parameter set being changed, displayed in
and with at least one of these optional parameters:
:timer = < 2, 3, 4 >
:tvalue = <dependent on the parm value>
if timer = 2, tvalue = 10 - 30000 milliseconds
if timer = 3, tvalue = 100 - 60000 milliseconds
if timer = 4, tvalue = 100 - 10000 milliseconds
:parm = < 1, 2, 3, 4 >
:pvalue = <dependent on the parm value>
if parm = 1, see the Valid PVALUE Parameter
Values if PARM =1 table
if parm = 2, see the Valid PVALUE Parameter
Values if PARM =2 table
if parm = 3, see the Valid PVALUE Parameter
Values if PARM =3 table
if parm = 4, see the Valid PVALUE Parameter
Values if PARM =4 table
Notes:
1. The timer and tvalue parameters must be specified
together. If one is specified, the other must be
specified.
2. The parm and pvalue parameters must be specified
together. If one is specified, the other must be
specified.
3. The tables that are referenced in the pvalue
parameter description are in the Changing a UA
Parameter Set" procedure in the Database
Administration Manual

Figure 124: Changing a UA Parameter Set

Turning Off the Large MSU Support for IP Signaling Feature

This procedure is used to turn off the Large MSU Support for IP Signaling feature, using the
chg-ctrl-feat command.
910-6278-001 Revision A, January 2012
Enter the
rtrv-uaps command with this
parameter.
:set=< UA parameter set to
change, 1 - 9 >
Is a UA parameter
Yes
set to be copied to another
UA parameter set?
No
parameter.
the rtrv-uaps output>
IP7 Secure Gateway.
IPSG M2PA and M3UA Configuration Procedures
Enter the
rtrv-uaps command with
this parameter.
:set=< UA parameter set
that is being copied,
1 - 10 >
Enter the chg-uaps command with
these parameters.
:set=<UA parameter set that is
being changed, 1 -9 >
:scrset = < UA parameter set
that is being copied, 1 - 10 >
Notes:
1. The set and scrset parameter
values cannot be the same.
2. If the scrset parameter is
specified, no other optional
parameter may be specified.
Enter the
rtrv-uaps command with this
parameter.
:set=<UA parameter set that
was changed>
Enter the
chg-db:action=backup:dest=fixed
command.
1027