Tekelec IP7 Secure Gateway Administration Manual page 732

Database Administration Manual - IP7 Secure
Gateway
Enter the canc-cmd:trm=<xx>, where <xx> is the terminal where the rtrv-assoc command
was entered, from another terminal other that the terminal where the rtrv-assoc command was
entered. To enter the canc-cmd:trm=<xx> command, the terminal must allow Security
Administration commands to be entered from it and the user must be allowed to enter Security
Administration commands. The terminal's permissions can be verified with the rtrv-secu-trm
command. The user's permissions can be verified with the rtrv-user or rtrv-secu-user
commands.
For more information about the canc-cmd command, go to the Commands Manual.
1. Display the associations in the database using the rtrv-assoc command. This is an example of
possible output.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
ANAME
swbel32
a2
a3
assoc3
Perform one of these actions.
If the desired IP link (shown by the entries in the CARD LOC and IPLNK PORT columns for an
association whose ADAPTER value is M2PA) is shown in the rtrv-assoc output, continue the
procedure with
If the desired IP link is not shown in the rtrv-assoc output, continue the procedure with
4.
2. Display the card that the new M2PA association will be assigned to by entering the rtrv-card
command with the card location displayed in
rtrv-card:loc=1203
The following is an example of the possible output.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
CARD TYPE
1203 ENET
If the value in the TYPE column is IPSG, continue the procedure with
If the value in the TYPE column is either IPLIM or IPLIMI, the host assigned to this card cannot be
used in this procedure. If you wish to use this card to configure an M2PA association, perform the
Adding an M2PA Association
If you do not wish to use this card to configure an IPSG M2PA association, perform one of these
actions.
Choose another card from the rtrv-assoc output in
Continue the procedure with
M2PA association.
3. Display the associations assigned to the card that the new association will be assigned to by entering
the rtrv-assoc command with the card location specified in
command.
rtrv-assoc:loc=1203
910-6278-001 Revision A, January 2012
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A M3UA
1305 A A SUA
1307 A A SUA
1203 A A1 M2PA
Step 2.
APPL LSET NAME
IPSG m2pa1
procedure.
Step 4 to choose another IPSG card and IP link for the new IPSG
IPSG M2PA and M3UA Configuration Procedures
1030 2345 YES
1030 2345 YES
1030 2346 YES
2048 1030 NO
Step 1. For this example, enter this command.
LINK SLC LSET NAME
A1 0
Step 1 and repeat this step.
Step 2. For this example, enter this
YES
YES
YES
NO
LINK SLC
Step 3.
Step
732