Tekelec IP7 Secure Gateway Administration Manual page 698

Database Administration Manual - IP7 Secure
Gateway
or fcnb and fcnbmask parameter values of the chg-netopts command. Continue the procedure
with Step 13.
13. Display the associations referencing the local host name that is associated with the IP link being
changed by entering the rtrv-assoc command and specifying the local host name shown in the
rtrv-ip-host output in
For this example, enter this command.
rtrv-assoc:lhost="ipnode-1201"
This is an example of the possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
ANAME
swbel32
IP Appl Sock/Assoc table is (3 of 4000) 1% full
Assoc Buffer Space Used (16 KB of 3200 KB) on LOC = 1201
If no associations are displayed in this step, continue the procedure with
If the rtrv-assoc output shows that the open parameter for any associations is yes, perform
the Changing the Attributes of an IPSG Association
parameter the associations to no.
14. Change the link parameters associated with the IP card in the database using the chg-ip-lnk
command.
For this example, enter this command.
chg-ip-lnk:loc=1201:port=a:ipaddr=192.1.1.10:submask=255.255.255.0
:auto=yes:mactype=dix
When this command has successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:18:37 GMT EAGLE5 36.0.0
CHG-IP-LNK: MASP A - COMPLTD
15. Verify the new link parameters associated with the IP card that was changed in
the rtrv-ip-lnk command with the card location specified in
For this example, enter this command.
The following is an example of the possible output.
rlghncxa03w 07-05-28 21:14:37 GMT EAGLE5 37.0.0
LOC PORT IPADDR
1201 A 192.1.1.10
1201 B --------------- --------------- HALF
16. Allow the IP card that was inhibited in
Note: If Step 8
For example, enter this command.
alw-card:loc=1201
910-6278-001 Revision A, January 2012
Step 2.
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A
SUBMASK
255.255.255.128 HALF
was not performed, continue the procedure with
IPSG M2PA and M3UA Configuration Procedures
M2PA 1030 2345
procedure to change the value of the open
DUPLEX
Step 8 by using by using the alw-card command.
YES YES
Step 14.
Step 14
Step 14.
SPEED MACTYPE AUTO MCAST
10 DIX YES
10 DIX NO
Step 18.
by entering
NO
NO
698