Tekelec IP7 Secure Gateway Administration Manual page 868

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 2
MAXSLKTPS values of the
linkset exceed the maximum
Note: The maximum total
provisioned system TPS
cannot be increased
beyond 750,000 TPS.
Perform the Activating the
HIPR2 High Rate Mode Feature"
procedure to enable and turn on
the HIPR2 High Rate Mode
feature. When the HIPR2 High
Rate Mode feature is enabled
and turned on, the maximum
total provisioned system TPS
value is increased to 750,000.
Sheet 3 of 4
910-6278-001 Revision A, January 2012
What is the
Yes
current IPSG value of
the linkset?
No
Enter the rtrv-tps
command.
Will the
RSVDSLKTPS or the
No
total provisioned
system TPS?
Yes
What is
the maximum total
750,000
provisioned system TPS
value? See
the Note.
500,000
IPSG M2PA and M3UA Configuration Procedures
Will the card's
maximum TPS value (5000) be
exceeded when the chg-card
command is executed?
Change the RSVDSLKTPS
value of the linkset, and the
No
MAXSLKTPS value if
necessary, by performing the
Changing an IPSG M2PA
Linkset" procedure. Perform this
procedure for each linkset
shown in the rept-stat-card
output on Sheet 1 as necessary.
Change the MAXSLKTPS value
of the linkset, and the
RSVDSLKTPS value if
necessary, by performing the
Changing an IPSG M2PA
Linkset" procedure. Perform this
procedure for each linkset shown
in the rept-stat-card output on
Sheet 1 as necessary.
Enter the chg-card command
with these parameters.
:loc=<the location of the card
that is being changed>
:nappl=ipsg
To
Sheet 4
Yes
868