Database Administration Manual - IP7 Secure
Gateway
The port parameter can be used in place of the link parameter to specify the signaling link
assigned to the association.
When each of these commands have successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
ENT-ASSOC: MASP A - COMPLTD
Note: If the association added in step 6 is not being activated in this procedure, skip step 7 and go
to step 8.
7. Activate the association added in
name specified in
command.
chg-assoc:aname=assoc1:open=yes:alw=yes
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 21:15:37 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD
8. Verify the changes using the rtrv-assoc command specifying the association name specified in
Step 6
Step
and
rtrv-assoc:aname=assoc1
This is an example of possible output.
rlghncxa03w 09-05-28 09:12:36 GMT EAGLE5 41.0.0
ANAME assoc1
LOC
ADAPTER
LHOST
ALHOST
RHOST
ARHOST
LPORT
ISTRMS
RMODE
RTIMES
OPEN
RHOSTVAL RELAXED
IP Appl Sock table is (5 of 4000) 1% full
Assoc Buffer Space Used (16 KB of 800 KB) on LOC = 1305
9. Back up the new changes, using the chg-db:action=backup:dest=fixed command. These
messages should appear; the active Maintenance and Administration Subsystem Processor (MASP)
appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
910-6278-001 Revision A, January 2012
Step 6
Step 6
and the open=yes and alw=yes parameters. For example, enter this
7. For this example, enter these commands.
1305
IPLNK PORT
M3UA
VER
gw105.nc.tekelec.com
---
gw100.nc.tekelec.com
---
1030
RPORT
2
OSTRMS
LIN
RMIN
10
CWMIN
YES
ALW
IETF M3UA and SUA Configuration Procedures
by entering the chg-assoc command with the association
A
M3UA RFC
1030
2
120
3000
YES
LINK
A
BUFSIZE
16
RMAX
800
UAPS
10
RTXTHR
0
376
Need help?
Do you have a question about the IP7 Secure Gateway and is the answer not in the manual?
Questions and answers