Tekelec IP7 Secure Gateway Administration Manual page 666

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-ls
command.
Enter the rtrv-dstn
command with this
parameter:
:dpc/dpca/dpci/dpcn/
dpcn24=<APC value for
the linkset being added>
Enter the rtrv-rtx command
with this parameter:
:dpc/dpca/dpci/dpcn/
dpcn24=<New APC for the
linkset>
Is the
APC of the linkset being
added in this procedure in
the rtrv-rtx output?
Enter the rtrv-rte command with
this parameter:
:dpc/dpca/dpci/dpcn/dpcn24=<New
APC for the linkset>
Is the
APC of the linkset
being changed in this
procedure in the rtrv-rte
output as the DPC of
a route?
No
To
Sheet 2
Sheet 1 of 5
910-6278-001 Revision A, January 2012
The APC of this linkset
cannot be shown in the
rtrv-ls output.
Yes
APC of the linkset being
added in this procedure in
the rtrv-dstn output?
Perform the Adding a
Destination Point Code"
procedure to add the required
point code to the database.
Yes
choose another APC
No
Perform the Removing a
Route Exception Entry"
procedure to remove all
the entries shown in the
Yes
choose another APC
Perform the Removing
a Route" procedure to
remove all the entries
shown in the rtrv-rte
IPSG M2PA and M3UA Configuration Procedures
Enter the rtrv-sid
Is the
Enter the rtrv-dstn
No
Sheet 2
This point code
Do you wish to cannot be used as
Yes
the APC of this
for the linkset? linkset. Choose
another point code.
No
rtrv-rtx output.
Do you wish to
Yes
for the linkset?
No
output.
command.
command.
To
666