Figure 66: Removing A Routing Key Containing An Application Server - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
Enter the dlt-appl-rtkey command with the
parameter combinations shown in the
Routing Key Parameter Combinations for
Removing Routing Keys table in this
procedure, and the values shown in the
previous step, depending on the type of
routing key being removed.
Enter the rtrv-appl-rtkey
command with the routing key
parameters and values specified
in the dlt-appl-rtkey command
(dpc, si, opc, cics, cice, ssn,
asname, sname, type, loc, and
rcontext, as applicable).
Were any
associations changed
on Sheet 1?
Sheet 2 of 2

Figure 66: Removing a Routing Key Containing an Application Server

910-6278-001 Revision A, January 2012
chg-assoc command with these
Yes
:aname=<association name>
Repeat this step for each association
that was changed on Sheet 1.
No
chg-db:action=backup:dest=fixed
IETF M3UA and SUA Configuration Procedures
Enter the
parameters
:open=yes
Enter the
command
505