Removing An Ipsg Association; Figure 107: Removing An Ip Route - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Enter the
rtrv-ip-rte command
Enter the
rept-stat-card:loc=<location of
IP card containing the IP route
being removed> command
Is the state of
the IP card
OOS-MT-DSBLD?
Do you wish to
place the IP card in the
OOS-MT-DSBLD
state?
(See Caution)
Enter the
dlt-ip-rte command with the
:force=yes parameter and at lease
one of these parameters:
:loc=<IP card location>
:dest = <IP address of the remote
host or network>
Caution: Removing an IP route while
the IP card is still in service can result
in losing the ability to route outbound
IP traffic on the IP card. This can
cause both TCP and SCTP sessions
on the IP card to be lost.

Figure 107: Removing an IP Route

Removing an IPSG Association

This procedure is used to remove an IPSG association from the database using the dlt-assoc
command. An IPSG association is an M2PA or M3UA association that is assigned to an IPSG card.
910-6278-001 Revision A, January 2012
Yes
No
Enter the
Yes
inh-card:loc=<IP card
containing the IP route being
removed> command
No
Enter the
rtrv-ip-rte command
Does the IP
card contain other IP
IPSG M2PA and M3UA Configuration Procedures
Enter the
dlt-ip-rte command with at lease one
of these parameters:
:loc=<IP card location>
:dest = <IP address of the remote
host or network>
alw-card:loc=<IP card location
specified in the dlt-ip-rte
routes?
command> command
No
chg-db:action=backup:dest=fixed
Enter the
Enter the
command
834