Table 55: Ipsg M3Ua Signaling Link Parameter Combinations - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
in this step contains a unique routing context value, compared to the routing context values shown
Step 13, continue the procedure with
in
If the linkset displayed in this step does not contain a unique routing context value, perform the
Changing an IPSG M3UA Linkset
is unique, compared to the routing context values shown in
M3UA Linkset
15. Add the signaling link to the database using the ent-slk command.

Table 55: IPSG M3UA Signaling Link Parameter Combinations

can be specified with the ent-slk command.
Table 55: IPSG M3UA Signaling Link Parameter Combinations
:loc = location of the IPSG card
:link = a - a15, b - b15
:lsn = linkset name
:slc = 0 - 15
:aname = the name of the IPSG M3UA association
For this example, enter this command.
ent-slk:loc=2204:link=a10:lsn=lsipgw:slc=1:aname=m3ua4
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-07 08:29:03 GMT
ENT-SLK: MASP A - COMPLTD
Note: If adding the new signaling link will result in more than 700 signaling links in the database
and the OAMHCMEAS value in the rtrv-measopts output is on, the scheduled UI measurement
reports will be disabled.
16. Verify the changes using the rtrv-slk command with the card location and link parameter
values specified in
rtrv-slk:loc=2204:link=a10
This is an example of the possible output.
rlghncxa03w 06-10-19 21:16:37 GMT EAGLE5 36.0.0
LOC LINK LSN
2204 A10 lsipgw
17. If any cards contain the first signaling link on a card, those cards must be brought into service with
the rst-card command, specifying the location of the card. For this example, enter this command.
rst-card:loc=2205
910-6278-001 Revision A, January 2012
procedure to change the routing context value in this linkset that
procedure has been performed, continue the procedure with
IPSG M3UA Signaling Link
Mandatory Parameters
Step 15. For this example, enter these commands.
SLC TYPE
1 IPSG
IPSG M2PA and M3UA Configuration Procedures
Step 15.
Step
shows the parameters and values that
EAGLE5 36.0.0
ANAME
m3ua4
13. After the Changing an IPSG
Step 15.
SLKTPS
500
786