Tekelec IP7 Secure Gateway Administration Manual page 472

Database Administration Manual - IP7 Secure
Gateway
BPDCM GPL
IMT BUS A
IMT BUS B
SIGNALING LINK STATUS
SLK PST
A IS-NR
Command Completed.
If the status of the card is out-of-service maintenance disabled (OOS-MT-DSBLD), continue the
procedure with
If the status of the card is not out-of-service maintenance disabled (OOS-MT-DSBLD), continue the
procedure with
4. Display the status of the signaling link assigned to the card shown in
rept-stat-slk command with the card location used in
this example, enter this command.
rept-stat-slk:loc=1107:link=a
This is an example of the possible output.
rlghncxa03w 08-04-27 17:00:36 GMT EAGLE5 38.0.0
SLK LSN
1107,A lsgw1107
ALARM STATUS
UNAVAIL REASON
Command Completed.
If the status of the signaling link is out-of-service maintenance disabled (OOS-MT-DSBLD), continue
the procedure with
If the status of the signaling link is not out-of-service maintenance disabled (OOS-MT-DSBLD),
any in-service IP connections on the signaling link must be placed out of service. Continue the
procedure by performing one of these steps.
The recommended method is to have the far end node place these IPconnections out of service.
Have the far-end node for the signaling link shown in
in either the ASP-INACTIVE or ASP-DOWN state. After the IP connections have been placed
out of service, continue the procedure with
If you do not wish to have the far end node place these IPconnections out of service, continue
the procedure with
5. Display the IP link associated with the card that the signaling link shown in
by entering the rtrv-ip-lnk command with the card location shown in
enter this command.
rtrv-ip-lnk:loc=1107
The following is an example of the possible output.
rlghncxa03w 08-04-28 21:14:37 GMT EAGLE5 38.0.0
LOC PORT IPADDR
1107 A 192.3.1.10
1107 B --------------- --------------- HALF
6. Display the IP host information associated with the IP link by entering the rtrv-ip-host command
with the IP address shown in
rtrv-ip-host:ipaddr=192.003.001.010
910-6278-001 Revision A, January 2012
= 002-102-000
= Conn
= Conn
LS
lsgw1107
Step 12.
Step 4.
CLLI
----------- IS-NR
= No Alarms.
= NA
Step 12.
Step 5.
SUBMASK
255.255.255.128 HALF
Step 5. For this example, enter this command.
IETF M3UA and SUA Configuration Procedures
CLLI
-----------
Step 3
PST SST
Avail
Step 4 place the M3UA or SUA associations
Step 10.
DUPLEX SPEED MACTYPE AUTO MCAST
10
10
Step 3 by entering the
and the link=a parameter. For
AST
-----
Step 4 is assigned to
Step 4. For this example,
802.3 NO NO
DIX NO NO
472