Changing Ipsg Components; Changing An Iplimx Card To An Ipsg Card - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway

Changing IPSG Components

This section describes how to change the attributes of the following components in the database.
Changing an IPLIMx card that contains IPLIMx M2PA signaling links to an IPSG card that contains
IPSG M2PA signaling links – perform the
IP options – perform the
The options for an IPSG M3UA linkset – perform the
procedure.
An IPSG Linkset – Perform these procedures.
Changing an IPSG M2PA Linkset
Changing an IPSG M3UA Linkset
An IPSG Association – Perform these procedures.
Changing the Attributes of an IPSG Association
Changing the Buffer Size of an IPSG Association
Changing the Host Values of an IPSG Association
The SCTP retransmission parameters – Perform the
Retransmission Control
The SCTP Checksum Algorithm – Perform these procedures.
Changing the SCTP Checksum Algorithm Option for IPSG M2PA Associations
Changing the SCTP Checksum Algorithm Option for IPSG M3UA Associations
The M2PA timer set for an IPSG M2PA association – perform the
procedure.
The UA parameter set for an IPSG M3UA association – perform the
procedure.
Turn off the Large MSU Support for IP Signaling feature – Perform the
Support for IP Signaling Feature

Changing an IPLIMx Card to an IPSG Card

This procedure is used to change an IPLIMx card to an IPSG card. The linksets, signaling links, and
M2PA associations that are assigned to the IPLIMx card are changed to IPSG M2PA linksets, IPSG
M2PA signaling links, and IPSG M2PA associations. To change an IPLIMx card to an IPSG card, the
chg-card command is used with these parameters.
:loc – The card location of the IPLIMx card.
:nappl – The new application that is assigned to the card, ipsg.
The IPLIMx card must be an E5-ENET card that is running either the IPLIM or IPLIMI applications.
IPLIMx signaling links must be assigned to the card. M2PA associations must be assigned to the
signaling links. Before the chg-card command can be executed, the IPLIMx card and its signaling links
must be taken out of service.
910-6278-001 Revision A, January 2012
Changing an IPLIMx Card to an IPSG Card
Configuring IP Options
procedure.
procedure.
IPSG M2PA and M3UA Configuration Procedures
procedure.
Configuring IPSG M3UA Linkset Options
Configuring an IPSG Association for SCTP
Changing an M2PA Timer Set
procedure.
Changing a UA Parameter Set
Turning Off the Large MSU
858