Figure 114: Configuring Ipsg M3Ua Linkset Options - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Enter the rept-stat-iptps
command.
Is the
ADAPTER parameter value
m3ua shown in the
rtrv-ls output?
Enter the chg-lsopts command with this mandatory parameter:
:lsn = <the name of the IPSG M3UA linkset>
and with at least one of these parameters:
Notes:
1. The values of the numslkalw, numslkrstr, or numslkproh parameters
cannot be greater than the number of signaling links that are assigned to
the linkset.
2. The value 0 for the numslkalw, numslkrstr, or numslkproh parameters is
considered to be half the number of signaling links assigned to the linkset.
3. The system default value for the numslkalw, numslkrstr, or numslkproh
parameters is 1.
4. If any optional parameter is not specified with the chg-lsopts command,
the value for that parameter will not be changed.
5. If the linkset does not contain any signaling links, only the values 0 or 1
can be specified for the numslkalw, numslkrstr, or numslkproh
parameters.
6. The value of the numslkrstr parameter must be less than or equal to the
numslkalw parameter value.
7. The value of the numslkproh parameter must be less than or equal to
the numslkrstr parameter value.

Figure 114: Configuring IPSG M3UA Linkset Options

910-6278-001 Revision A, January 2012
Are any
linksets shown in the
rept-stat-iptps
output?
Enter the rtrv-ls command with
this parameter.
:lsn=<the name of the linkset
shown in the LSN column of the
rept-stat-iptps output>
This linkset is not an IPSG
M3UA links and the procedure
No
cannot be performed on this
linkset. This procedure can be
performed only for IPSG M3UA
Yes
:numslkalw = <0 - 16>
:numslkrstr = <0 - 16>
:numslkproh = <0 - 16>
IPSG M2PA and M3UA Configuration Procedures
No
This procedure cannot be
performed.
Yes
Yes
linksets.
Do you wish to
perform this procedure
on another linkset?
Enter the rtrv-ls command with
this parameter.
:lsn=<the name of the linkset
specified in the chg-lsopts
command>
Enter the
chg-db:action=backup:dest=fixed
command
No
This procedure is
finished.
877