Tekelec IP7 Secure Gateway Administration Manual page 998

Database Administration Manual - IP7 Secure
Gateway
11. Change the value of the open parameter of the associations shown in
the chg-assoc command with the open=no parameter. For this example, enter this command.
chg-assoc:aname=assoc3:open=no
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
12. Change the value of the open parameter of the associations changed in
the chg-assoc command with the open=yes parameter. For this example, enter this command.
chg-assoc:aname=assoc3:open=yes
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
13. Verify the checksum algorithm that is assigned to the associations shown in
the sctp -a pass command with the card location of the IP card specified in
of the associations specified in
pass:loc=1315:cmd= sctp -a assoc3
The following is an example of the possible output.
rlghncxa03w 10-12-28 21:16:37 GMT EAGLE5 43.0.0
Aname
assoc3
Retransmission Mode = LIN
Min. Retransmission Timeout = 10000
Max. Retransmission Timeout = 800000
Max. Number of Retries = 10
Min. Congestion Window
Outbound Streams = 2
Checksum Algorithm = crc32c
Send/Rcv Buffer Size = 204800
IP Address
ssthresh
IP Address
ssthresh
910-6278-001 Revision A, January 2012
Step 12. For this example, enter this command.
Local
IP Address
192.1.1.50
192.1.1.50
Configuration
= 3000
Inbound Streams = 2
192.168.112.4
Port 1025
MTU 1500
16384
192.168.112.5
Port 7777
MTU 1500
16384
Last Net Sent To = 192.168.112.4
Last Net Rcvd From = 192.168.112.4
Over All Eror Count = 0
Peers Rwnd = 13880
My Rwnd = 16384
Max Window = 16384
Initial Seq Number = 24130
IPSG M2PA and M3UA Configuration Procedures
Local Primary
Port Address
2345 192.168.112.4
State = OPEN
ULP association id = 18
Number of nets = 2
Inbound Streams = 1
Outbound Streams = 2
Nets Data
State
Primary
cwnd
RTO
State
Primary
cwnd
RTO
Step 3 to no by specifying
Step 11 to yes by specifying
Step 12 by entering
Step 8 and the name
Remote
Port
1025
State
Reachable
YES
16384
120
Reachable
NO
16384
120
998