Tekelec IP7 Secure Gateway Administration Manual page 1010

Database Administration Manual - IP7 Secure
Gateway
Timer Draft 6
Timer
Name
Alignment
:t1
Timer
:t2 * N/A
N/A
:t3
Ready
Timer
Proving Timer
:t4n
(Normal)
Proving Timer
:t4e
(Emergency)
Busy Rate Timer
:t5
910-6278-001 Revision A, January 2012
RFC Definition
Timer
Name
The amount of time the M2PA
adapter layer waits to receive
N/A
a Link Status Alignment
message from the peer.
The the amount of time the
M2PA adapter layer waits to
receive a Link Status
Not
Alignment/Link Status
Aligned
Proving message after sending
Timer
a Link Status Alignment
message. Timer T2 is not used
in M2PA Draft 6 timer sets.
The amount of time the M2PA
Alignment layer waits to receive a Link
Timer Status Alignment message from
the peer.
The amount of time after
proving the M2PA adapter
N/A layer waits to receive a Link
Status Ready message from the
peer.
The amount of time the M2PA
adapter layer generates Link
Status Proving messages
during normal proving.
The amount of time the M2PA
adapter layer generates Link
Status Proving messages
during emergency proving.
The amount of time between
sending Link Status Busy
messages while the link is
in-service.
IPSG M2PA and M3UA Configuration Procedures
Value (in
msecs)
1000 -
350000
5000 -
150000
1000 -
60000
1000 -
60000
1000 -
70000
400 - 5000
80 - 10000
DRAFT 6 RFC
System System
Default Default
Value (in Value (in
msecs) msecs)
10000 N/A
N/A 20000
N/A 2000
10000 N/A
10000 30000
500 500
1000 100
1010