Tekelec IP7 Secure Gateway Administration Manual page 310

Database Administration Manual - IP7 Secure
Gateway
14. Change the linkset shown in
action=add parameters.
For this example, enter this command.
chg-ls:lsn=lsgw1103:matelsn=lsgw1107:action=add
When the chg-ls command has successfully completed, this message should appear.
rlghncxa03w 08-04-17 16:23:21 GMT
Link set table is ( 14 of 1024)
CHG-LS: MASP A - COMPLTD
15. Verify the changes using the rtrv-ls command specifying the linkset name specified in
with the lsn parameter. For this example, enter this command.
rtrv-ls:lsn=lsgw1103
This is an example of the possible output.
rlghncxa03w 08-04-17 11:43:04 GMT EAGLE5 38.0.0
LSN
lsgw1103
CLLI
-----------
IPGWAPC
yes
LOC
1103 A
Link set table is ( 14 of 1024)
If the linkset shown in this step does not have a signaling link assigned to it, or if the dact-slk
command in Step 12
16. Allow the IP card that was inhibited in
this command.
alw-card:loc=1103
This message should appear.
rlghncxa03w 08-04-28 21:21:37 GMT EAGLE5 38.0.0
Card has been allowed.
17. Activate the signaling link from
command.
act-slk:loc=1103:link=a
The output confirms the activation.
rlghncxa03w 08-04-07 11:11:28 GMT EAGLE5 38.0.0
Activate Link message sent to card
If Step 10 and
18. Change the open and alw parameter values for all the associations changed in
using the chg-assoc command with the open=yes and alw=yes parameters.
910-6278-001 Revision A, January 2012
Step 2 by entering the chg-ls command with the matelsn and
APCA (SS7) SCRN
003-002-004 none
TFATCABMLQ MTPRSE ASL8
1
MATELSN
lsgw1107
LINK SLC TYPE
0 SS7IPGW
was not performed, continue the procedure with
Step 12
Step 11 were not performed, continue the procedure with
IETF M3UA and SUA Configuration Procedures
EAGLE5 38.0.0
1% full
L3T SLT
SET SET BEI LST LNKS ACT MES DIS SLSCI NIS
1 1 no A 1
no no
IPTPS LSUSEALM SLKUSEALM GTTMODE
10000 70 % 70
1% full
Step 13 using the alw-card command. For example, enter
using the act-slk command. For example, enter this
GWS GWS GWS
off off off no off
% CdPA
Step 20.
Step 19.
Step 10 or
Step 14
Step 11
310