Tekelec IP7 Secure Gateway Administration Manual page 515

Database Administration Manual - IP7 Secure
Gateway
This is an example of possible output.
rlghncxa03w 08-04-06 15:17:20 EST EAGLE5 38.0.0
CARD TYPE
1205 DCM
If the application assigned to the card is IPSG, perform
If the application assigned to the card is SS7IPGW or IPGWI, continue the procedure with
3. Continue the procedure by performing one of these actions.
If the application assigned to the card is SS7IPGW or IPGWI, shown in the APPL column, and the
values of any of these parameters are being changed: lport, rhost, rport, adapter, rmode,
rmin, rmax, rtimes, cwmin, istrms, ostrms, or uaps, continue the procedure by performing
one of these actions.
If the open parameter value for the association is yes, continue the procedure with
If the open parameter value for the association is no, continue the procedure with
If the application assigned to the card is SS7IPGW or IPGWI, shown in the APPL column, and only
the values of the alw, open, or rtxthr parameters are being changed, continue the procedure
by performing one of these actions.
If only the values of the alw parameter is being changed, or the open parameter value is being
changed to no, continue the procedure with
If the value of the rtxthr parameter is being changed, continue the procedure with
If the value of the open parameter value is being changed to yes, a signaling link must be
assigned to the card shown in this step. If
If a signaling links is assigned to the card, entries area shown in the LSET NAME and LINK
columns of the rtrv-card output in
one of these actions.
If only the alw parameter is being specified with the open=yes parameter, continue the
procedure with
If the value of the rtxthr parameter is being changed, continue the procedure with
6.
If the value of the open parameter value is being changed to yes and a signaling link is not
assigned to the card,
link to the card. After the signaling link has been added, perform one of these actions.
If only the alw parameter is being specified with the open=yes parameter, continue the
procedure with
If the value of the rtxthr parameter is being changed, continue the procedure with
6.
If the value of the open parameter value is being changed to yes, and
continue the procedure with
4. Display the signaling link that is assigned to the card containing the association that is being
changed by entering the rtrv-slk command with the location of the card. For this example, enter
this command.
rtrv-slk:loc=1205
910-6278-001 Revision A, January 2012
APPL LSET NAME
SS7IPGW e5e6a
Step
Step 12.
performAdding an IPGWx Signaling Link
Step 12.
Step 4.
IETF M3UA and SUA Configuration Procedures
LINK SLC LSET NAME
A 0
Changing the Attributes of an IPSG
Step 12.
Step 2 was performed, perform one of these actions.
2. If a signaling link is assigned to the card, perform
LINK SLC
Association.
Step
Step
Step
to assign an IPGWx signaling
Step 2 was not performed,
Step 3.
5.
6.
6.
Step
Step
515