Figure 99: Adding An Ipsg M3Ua Association - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
Enter the rtrv-assoc
command with this
parameter.
:lhost=<local host name
that will be assigned to the
new association>
What is the
available buffer size of the
card that the association will
be assigned to ?
Do you wish to
change the buffer size
of any of the associations
currently assigned to the
card?
Notes:
1. The EAGLE 5 ISS can contain a maximum of 4000 connections (association – application
server assignments).
2. A maximum of 32 IPSG M2PA or M 3UA associations can be assigned to the IPSG card.
3. The value of the lhost, rhost, or alhost parameters is a text string of up to 60 characters,
with the first character being a letter. The command line on the terminal can contain up to 150
characters. If the host names are too long to fit on the ent-assoc command line, perform the
chg-assoc command with the parameters and values necessary to complete the entry of the
IPSG M3UA association.
4. To activate the association after the association is assigned to a signaling link , the
association must contain values for the lhost, rhost, lport, and rport parameters.
5. If the lhost and alhost parameters are specified, the lhost parameter value represents the IP
address corresponding to one of the network interfaces (A or B) on the IP card while the
alhost parameter value represents the IP address corresponding to the other network
interface of the same IP card.
Sheet 2 of 2

Figure 99: Adding an IPSG M3UA Association

910-6278-001 Revision A, January 2012
Was a new host
name added on
Sheet 1?
No
16 or
greater
Less than
16
Perform the Changing the
Buffer Size of an IPSG
Association" procedure to
Yes
change the buffer size of the
associations assigned to the
card to allow the new
association to be added to
No
The new association
cannot be added.
IPSG M2PA and M3UA Configuration Procedures
Yes
ent-assoc command with these
mandatory parameters:
:aname=<association name>
:lhost = <local host name from the
rtrv-ip-host output>
:adapter = m3ua
and with at least one of these optional
parameters.
:lport = <local port ID>
:rhost = <remote host name>
:rport = <remote port ID>
:alhost = <alternate local host name from
the rtrv-ip-host output>
(See Notes 1 through 5)
Enter the rtrv-assoc command
with this parameter.
:aname=<the name of the
association specified with the
ent-assoc command>
chg-db:action=backup:dest=fixed
the card.
Enter the
Enter the
command.
750