Tekelec IP7 Secure Gateway Administration Manual page 875

Database Administration Manual - IP7 Secure
Gateway
Link set table is (13 of 1024) 1% full.
IPSG M3UA linksets are shown by the entry m3ua in the ADAPTER column of the rtrv-ls output.
If the linkset is an IPSG M3UA linkset, continue the procedure with
If the linkset is not an IPSG M3UA linkset, perform one of these actions.
Choose another linkset from
If you do not wish to choose another linkset, the remainder of this procedure cannot be
performed. This procedure is finished.
3. Change the IPSG M3UA linkset options by entering the chg-lsopts command.
For this example, enter this command.
chg-lsopts:lsn=ipsgm3ua:numslkalw=3:numslkrstr=2:numslkproh=2
The value of the numslkalw, numslkrstr, or numslkproh parameters cannot exceed the number
of signaling links that are assigned to the linkset.
The value of the numslkrstr parameter must be less than or equal to the numslkalw parameter
value.
The value of the numslkproh parameter must be less than or equal to the numslkrstr parameter
value.
When this command has successfully completed, the following message should appear.
rlghncxa03w 08-04-28 21:18:37 GMT EAGLE5 38.0.0
Link set table is (13 of 1024) 1% full.
CHG-LSOPTS: MASP A - COMPLTD
4. Verify the changes by entering the rtrv-ls command with the name of the linkset specified in
Step 3. For this example, enter this command.
rtrv-ls:lsn=ipsgm3ua
The following is an example of the possible output.
rlghncxa03w 08-04-28 21:17:37 GMT EAGLE5 38.0.0
LSN
ipsgm3ua
---------------- -----------
RANDSLS
off
IPSG
yes
ADAPTER
m3ua
TPSALM
rsvdslktps 100%
910-6278-001 Revision A, January 2012
Step 1 and repeat this step.
APCA (SS7) SCRN SET SET BEI LST LNKS ACT MES DIS SLSCI NIS
008-008-004 none 1
SPCA CLLI
IPGWAPC GTTMODE
no CdPA
RSVDSLKTPS
100
LSUSEALM
IPSG M2PA and M3UA Configuration Procedures
L3T SLT
1 no A 5
TFATCABMLQ MTPRSE ASL8
---
CGGTMOD
no
MAXSLKTPS
500
SLKUSEALM
80%
Step 3
GWS GWS GWS
off off off no
--- no
off
875