Tekelec IP7 Secure Gateway Administration Manual page 966

Database Administration Manual - IP7 Secure
Gateway
parameter to be specified
Enter the rtrv-m2pa-tset command
with one of these parameters.
:ver=d6 – to display the Draft 6
version of the M2PA timer set
:ver=rfc – to display the RFC version
If neither parameter is specified with
the rtrv-m2pa-tset command, both
versions of the M2PA timer set are
set defined with the desired
Perform the "Changing an M2PA
Timer Set" procedure in this
chapter to change the desired
timer set with the desired values.
Sheet 4 of 6
910-6278-001 Revision A, January 2012
From
Sheets 2
or 3
What is the new
M2PA
ADAPTER value of the
association?
Is the m2patset
No
with the chg-assoc
command?
Yes
of the M2PA timer set
displayed.
Is the
desired M2PA timer
Yes
values? See the
Note.
No
See Caution 1.
IPSG M2PA and M3UA Configuration Procedures
M3UA
Is the uaps
parameter to be specified
with the chg-assoc
command?
Yes
Enter the
rtrv-uaps command with this
parameter.
:uaps = <UAPS set number, 1 - 10>
Is the desired
UA parameter set
defined with the desired
values?
No
Perform the "Changing a UA
Parameter Set" procedure in
this chapter and change the
desired UA parameter set with
the desired values.
See Caution 2.
Note: If the mp2atset parameter is not specified with the
chg-assoc command, the m2patset parameter value
defaults to M2PA timer set 1 (m2patset=1).
Caution 1: Changing an M2PA timer set may affect the
performance of any associations using the timer set
being changed.
Caution 2: Changing a UA parameter set may affect
the performance of any associations using the UA
parameter set being changed.
No
Yes
To
Sheet 5
966